Bill Roper (billroper) wrote,
Bill Roper
billroper

Furnace Fixed

There was a bad flame sensor. Apparently, every time that I power cycled the furnace, it reset the microprocessor control so that it would try to start up again and would give us a little bit of heat. The furnace tech (the husband of one of daisy_knotwise's former coworkers) replaced the sensor and cleaned the furnace.

So far, so good.
Tags: home, musings
Subscribe

  • Design on the Fly

    The great thing about us and getting this kitchen done is that we are able to design on the fly. Our contractor came by, looked quickly at the…

  • Time to Rearrange

    I expect to hear back from the contractor on Monday and we'll discuss exactly how to fix things up in the kitchen. I don't think any of this will be…

  • Closer To Fine

    So the cabinets went in today, which is good. There are, sadly, two problems. First, there is a measurement glitch which resulted in the cabinets…

  • Post a new comment

    Error

    Anonymous comments are disabled in this journal

    default userpic

    Your reply will be screened

    Your IP address will be recorded 

  • 0 comments